This Wireless Water Leak Alarm detects water leaks when both electrodes are flooded. When the two sensors detect water, the red LED indicator light on the detector will be on and will transmit a wireless signal sending a message to the alarm base station. Once the wireless signal is received by the alarm base station […]
Monthly Archives: April 2022
Can I re-use the alarm if water has got on it?
Yes, the water alarm can be reused after it has been wet, by drying it using a soft clean cloth and place it back in the area you wish to monitor.
How and where do I install the Water Leak Alarm?
Place the alarm in an area which may flood such as basements, kitchens, utility rooms, bathrooms, etc. To avoid magnetic interference on the sensor, do not mount it on a magnetic surface such as a metal doorframe.
How do I pair the Water Leak Alarm with my base station?
Ensure the Alarm Base Station is plugged in and turned on: STEP 1. From the App on your phone, on Alarm home screen tap Accessories > +, then the base station goes into the pairing/sniffer mode with all indicators blinking. STEP 2. Touch the two sensors on the bottom of the water leak alarm at […]
Where should I install a smoke alarm?
You should install at least one smoke alarm for each floor in your home. For example, the ground floor and first floor if you live in a two-storey house. Put one in your hallway and one at each upper level in the landing area. Fit them between the sleeping areas and the kitchen and living […]
How will I be notified if the smoke alarm detects smoke?
The Smoke Alarm is in the working mode after installation, with the LED flashing once for every 45 seconds. When it detects smoke, the alarm will sound until the smoke is cleared from the detector. An SMS will be sent to all numbers listed in your “Alarm SMS number” list. The SMS will advise what […]
How do I install the smoke alarm?
Using Screw fixings – Choose the installation location, first make two holes in the ceiling or wall, then insert the wall plugs into the holes. Insert the screws into the holes of the plate, screw tightly to fix the bracket firmly. Fit the battery into the battery holder of the alarm, align the back of […]
How do I pair the smoke alarm with my base station?
Ensure the Alarm Base Station is plugged in and turned on: STEP 1. Open the back of the Smoke Alarm and remove the plastic covering from the battery. Re insert the batter taking time to ensure you have the battery + and – matched correctly. STEP 2. From the App on your phone, on the […]
How can I remove a nova unit from my WiFi network?
Hold down the Reset button for about 20 seconds until its LED turns white, or tap the nova unit on the Tenda WiFi app, tap in the upper-right corner, and choose Delete.
Why is my nova light red?
When the light is Solid red on the secondary units, it means that it’s disconnected from the primary unit.